Precor EFX546 Manual de Serviço descarregar pdf (Página 22)

C546 Elliptical Fitness Crosstrainer

Page 22

Procedure 5.2 - Calibrating the Lift Motor (version 1,2)

1. In order to correctly calibrate the lift the unit’s software version must be known. If the unit’s

software version is not known, access the software version per Procedure 3.3.

2. In order to calibrate the lift motor, it is necessary to disconnect the lift motor from the ramp

assembly.

3. Set the on/off switch in the “off” position. Remove the screws that retain the front cover and

remove the front cover.

4. Remove the four screws that retain the ramp end cap to the ramp assembly. Support the lift

motor and ramp assembly as you separate the ramp end cap from the ramp assembly.

Lower the ramp assembly until it is resting on the frame. (See Diagram 5.1)

Diagram 5.1 - Lift Motor Mounting

5. Do not remove the ramp end cap from the lift motor drive screw.

6. Set the on/off switch in the “on” position. Enter the diagnostics routine per Procedure 3.2.

After the L.E.D. test is complete, power bits will be displayed. Press the ENTER key to

display the lift calibration number.

Ramp End Cap

Ramp Assembly

Lift Motor

Drive Screw

Mounting

Screws

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 117 118

Sem comentários

Precor EFX546 Manual de Serviço Página 22